Seiko V-64S Guia do Utilizador descarregar pdf (Página 176)

4-28

Media advance value setting

The media advance setting varies depending on the thickness, elasticity and

frictional surface resistance. If the media advance value is wrong, banding

(horizontal stripes) may appear on the print. Use the following procedure to set

the appropriate media advance value.

The following factors that change the media advance value:

- Type of media

- Print mode

- Pressure change using the Pressure roller up/down lever

- Mode of take-up reel unit

- Media advance mode (FWD ONLY/BACK & FWD)

Media advance value setting procedure

Set the media of wider than A1 size in width and longer than 1m in length.

Set the rough media advance value by reading the print of advance adjustment

pattern in [ROUGH] and the media advance value in [DETAIL]. Both of [ROUGH]

and [DETAIL] prints need the paper of 40 cm to 50 cm in length per one print.

(The required paper diers in for dierent print modes.)

When the take-up reel unit is set to the tension winding, the print length

becomes longer.

(To stop the printing of advance adjustment pattern, press key.)

Set the printer to the oine.

(Press

key.)

Press key and then key to display

the advance adjustment pattern.

Select the normally used print mode in the

media to set the media advance value.

( P.3-25 [PRINT MODE])

St e p 1

hIN K MEDI A REG i

fME DIA M. ADVg

#M EDIA ADV PR INT

RO UGH (NO RMAL 1)

Print [ROUGH] g [DETAIL].

St e p 2

Reading the print result of adjustment pattern,

Print of adjustment pattern

enter the media advance value.

IP-5610取説_E.indb 28 09.4.3 3:15:17 PM

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 232 233

Sem comentários

Seiko V-64S Guia do Utilizador Página 176