Seiko 7C17 Manual do Utilizador descarregar pdf (Página 7)

21 Step Combination

S+ (solder pre-feed

amount)

CY 1 ON x.xx (iron tip

extend & pre-heat timer)

S+ (secondary solder feed)

S- (solder retract amount)

TIM (reflow timer)

CY1 OFF (retract iron tip)

End Condition

Work Parameter Settings

Group 01:

S+ Solder Feed Forward (amount)

S- Solder Feed Reverse (amount)

CY1 ON Extend Air Cylinder (timer)

CY1 OFF Retract Air Cylinder (timer)

TIM Timer (general use)

END End of Work Sequence

AIR Air Blow (tip cleaning timer)

ACK Slide Solder Timing Sequence

TEM Tip Temperature Setting (degrees)

Group 02:

OUT Output Signal (01 ~ 08 & duration

IN Input Signal (01 ~ 08) & duration

SET Turn On Output Signal

RST Reset Output Signal (turn off)

WST Wait for a Start Signal

JMP Jump to Alternate Program, continue

sequence without stopping

TE2 Second Temperature Setting “temp.

alarm Off)

LDS (x x) Turn on Laser Diode (wattage)

LDR Reset (turn off) Laser Diode

Sample Sequence:

S+ 2.5 25.0 Feed 2.5 mm of solder @ 25 mm / sec.

CY 1 ON 0.0 Tip Extend

TIM 0.5 Timer of 0.5 Seconds

S+ 3.0 10.0 Feed 3.0 mm of solder @ 10 mm / sec.

S- 3.0 25.0 Retract solder by 3 mm @ 25 mm/sec.

TIM 0.3 Solder dwell time after feed 0.3 sec.

CY 1 OFF Retract Iron Tip

END End of Sequence

Solder Parameter Solder WORK Profile Description Sheet (101, 102 & 103)

Explanation (Blocks 101~199 = Point Solder, Blocks 201~299 = Slide Solder, Blocks 301~399 = Special Condition)

Notes:

Tip Part #: Tip Temperature:

Work Data:

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comentários a estes Manuais

Sem comentários

Seiko 7C17 Manual do Utilizador Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com não Seiko 7C17