Seiko 7C17 Manual do Utilizador descarregar pdf (Página 3)

With Remote Interface Panel

Step 01: Power on the L-CAT EVO robot in the lower left hand corner of

the machine

Step 02: Press the HOME key on the remote panel to HOME the robot.

The iron unit power should start automatically.

Step 03: Press the HEATER key one time and check the SET

TEMPERATURE. Set the temperature according to the

application requirements (300 ~ 420 C) by using the UP/DOWN

arrows on the robot interface

Step 04: Select the correct program number using the program selector

(1-99)

Step 05: Press the GREEN START button to initiate a program sequence

The robot will be begin moving!

Button Description:

START Initiates a program sequence or restarts after a STOP signal

P. STOP This is a partial stop signal which will stop the robot during

running a sequence, START re-starts the robot

RESET Resets an error condition (temp error or solder clog)

HOME Homes the robot upon POWER UP

PROG Sel Select a program for operation (0-99)

E-STOP Stops the robot and kills power to the motors, a full system

re-start is required after an E-Stop condition

Item to Check:

a) Make sure the air is on to the machine (required for operation)

b) Make sure that the POWER, ORIGIN and STAND-BY LED’s are illuminated

c) Check the iron tip for wear prior to soldering

d) Check the sponges to ensure that they are saturated

e) Make sure that the upper line of the display shows the temperature of 360 Degrees Celsius

1 2 3 4 5 6 7 8 ... 43 44

Sem comentários

Seiko 7C17 Manual do Utilizador Página 3