Seiko LTP F Series Especificações descarregar pdf (Página 25)

-７

７７

７

6.5 CONSIDERATIONS FOR USING

(1) Do not back feed paper after cutting paper using the autocutter because it will cause a paper jam.

(2) To prevent paper from jamming, feed paper or print feed 7 mm or more after cutting paper.

(3) To make the most efficient use of paper, as shown in Figure 6-6, print the area A for the next print

portion after printing area B, and then cut the paper.

(4) When mounting the autocutter to the LTP F Series, the distance between the cut position and the

heat element of the thermal head is approximately 13 mm. Do not print on the cut position.

Figure 6-6 Using Paper Efficiently When Cutting

(5) Do not print continuosly over the print area A and the print area B. It causes a little gap between the

print area A and the print area B.

(6) The motor for the autocutter must drive in the normal rotation. (See page 3-3 (3) Connecting

Terminal and Chapter 4 Drive Method) Driving in the reverse rotation causes cutting failure.

ONE-TIME

PRINTING AREA

Print start position.

Cut position

PRINT AREA A

AREA B

PRINT AREA A

PRINT AREA B

Execute a paper cutting after printing

and the next

PRINT AREA B

PRINT AREA A

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

Sem comentários

Seiko LTP F Series Especificações Página 25