Seiko SLP240 Manual do Utilizador descarregar pdf (Página 11)

For example

Change baud rate Command

To 9600 C1 10 C1 11 C1 03 C1 AA

To 19200 C1 10 C1 01 C1 03 C1 AA

To 38400 C1 00 C1 11 C1 03 C1 AA

To 57600 C1 00 C1 01 C1 03 C1 AA

To 115200 C1 00 C1 01 C1 13 C1 AA

Feed mode (bit 2) - determines how paper feeding is handled by the printer.

When Label/Form mode is enabled, a form feed (either by command or the feed

button) causes the label or paper to be advanced to the next top-of-form mark. If

a top-of-form mark is not detected within the form length, a paper jam error

occurs. In Label Mode, the default form length is 255 mm (about 10 inches).

When in Continuous mode, the form feed command advances the paper to the next

increment of the form length and the feed button advances paper only while

pressed. The default form length is six inches, but may be adjusted with the

CMD_LENGTH command. In Continuous mode, paper jam detection is disabled

and a top-of-form mark will cause the feed mode to change to Label/Form.

Auto On-line (bit 5) - determines whether the printer will automatically go on-

line when buffered print commands are received, or remain in standby mode.

Media type (bit 6) - is used to match the energy level used for printing with the

thermal characteristics of the label media or paper media. This bit is set

automatically when the media type is detected during media loading.

The paper and label are the same printing control in SLP 440 and 450.

- 11 -

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sem comentários

Seiko SLP240 Manual do Utilizador Página 11